2014 Toyota Camry Suspension & Steering Torque Specs

OEM-referenced torque, socket, and thread specs for the 4 front and rear suspension and steering fasteners on the 2014 Toyota Camry — including the Ball Joint Nut (torques to 67 ft-lbs, 19mm socket, M14x2.0 thread). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2014 Toyota Camry

On the 2014 Toyota Camry, the control arms & ball joints fasteners are: Ball Joint Nut (torques to 67 ft-lbs, 19mm socket, M14x2.0 thread); Lower Control Arm Bolt (torques to 85 ft-lbs, 19mm socket, M14x2.0 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2014 Toyota Camry

On the 2014 Toyota Camry, the struts, shocks & springs fasteners are: Strut Mount Nut (torques to 47 ft-lbs, 14mm socket, M10x1.25 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Other Suspension Fasteners torque — 2014 Toyota Camry

On the 2014 Toyota Camry, the other suspension fasteners fasteners are: Wheel Lug Nut (torques to 76 ft-lbs (103 Nm), 21mm socket, M12x1.5 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque Camry suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…