2026 Toyota 4Runner Brake Job Torque Specs

OEM-referenced torque, socket, and thread specs for the 4 brake fasteners you touch on a 2026 Toyota 4Runner brake job — caliper mounting bolts, caliper bracket bolts, slide/guide pins, and rotor hardware, including the Caliper Bracket Bolt (torques to 85 ft-lbs, 17mm socket, M12x1.25 thread). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Caliper Mounting Bolts torque — 2026 Toyota 4Runner

On the 2026 Toyota 4Runner, the caliper mounting bolts are: Brake Caliper Pin (torques to 22 ft-lbs, 12mm socket, M8x1.25 thread). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

Caliper Bracket Bolts torque — 2026 Toyota 4Runner

On the 2026 Toyota 4Runner, the caliper bracket bolts are: Caliper Bracket Bolt (torques to 85 ft-lbs, 17mm socket, M12x1.25 thread). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

Rotor Retaining Hardware torque — 2026 Toyota 4Runner

On the 2026 Toyota 4Runner, the rotor retaining hardware are: Brake Rotor Set Screw (torques to 4 ft-lbs, 5mm socket, M5x0.8 thread). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

Hydraulic (Banjo & Bleeder) torque — 2026 Toyota 4Runner

On the 2026 Toyota 4Runner, the hydraulic (banjo & bleeder) are: Brake Line Banjo Bolt (torques to 25 ft-lbs, 10mm socket, M10x1.0 thread). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

How to do a 4Runner brake job right

Work one corner at a time so the other side holds a reference. Unbolt the caliper, hang it from the coil with wire (never let it dangle on the hose), and back the caliper bracket bolts out — those are the high-torque fasteners (commonly 80-140 ft-lbs) and are frequently torque-to-yield, so plan to replace them. Clean and lube the slide pins, or replace the pin boots if torn. Apply the specified thread-locker, start every bolt by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench. Pump the pedal to seat the pads before you drive, and re-torque the lug nuts after the wheels go back on.

Tools you need for a 4Runner brake job

The 2026 Toyota 4Runner brake job calls for 10mm, 17mm, 5mm, 12mm sockets, a caliper slide-pin tool or hex/Torx bit set, a torque wrench that covers the high bracket-bolt values, thread-locker, and brake grease for the slide pins. A caliper piston compressor makes seating the new pads far easier. See the recommended tools and replacement hardware linked below.

Related lookups

Loading interactive lookup…