2007 Toyota 4Runner Suspension & Steering Torque Specs

OEM-referenced torque, socket, and thread specs for the 3 front and rear suspension and steering fasteners on the 2007 Toyota 4Runner — including the Front Lower Control Arm Ball Joint (torques to 118 ft-lb, 19mm hex socket, M14 thread). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2007 Toyota 4Runner

On the 2007 Toyota 4Runner, the control arms & ball joints fasteners are: Front Lower Control Arm Ball Joint (torques to 118 ft-lb, 19mm hex socket, M14 thread); Upper Control Arm Through Bolt (torques to 85 ft-lb, 22mm hex socket, M16 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2007 Toyota 4Runner

On the 2007 Toyota 4Runner, the struts, shocks & springs fasteners are: TRD Strut Brace Bolt (torques to 29 ft-lbs, 14mm socket, M10x1.25 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque 4Runner suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…