2024 Toyota Corolla Lug Nut Torque Specs
The OEM lug nut torque for the 2024 Toyota Corolla is 80 ft-lbs (108 Nm) using a 21mm socket on M12x1.5 thread studs. Tighten in a star pattern in two passes — about half, then full — and re-check after the first 50 to 100 miles. Full bolt and torque specs for the rest of the vehicle are linked below.
What is the lug nut torque for the 2024 Toyota Corolla?
The OEM-specified lug nut torque for the 2024 Toyota Corolla is 80 ft-lbs (108 Nm). Use a calibrated torque wrench for the final pass — an impact gun cannot hit a precise value and is the most common cause of warped rotors and stretched studs. The studs are M12x1.5 thread. Re-torque after the first 50 to 100 miles of driving, because the clamp load settles as the wheel seats against the hub.
What socket size fits the Corolla lug nuts?
The 2024 Toyota Corolla uses a 21mm lug nut. Use a 6-point impact-rated socket rather than a 12-point chrome socket — 12-point sockets round off lug nuts under impact-driver use, which is the number-one reason a stuck nut ends up drilled out.
How to torque the Corolla wheels correctly
Thread every lug nut on by hand first to avoid cross-threading, then torque to 80 ft-lbs (108 Nm) in a star (criss-cross) pattern across two passes — roughly 50% then 100%. Never run one nut down fully before the others; it cocks the wheel and warps the rotor. Lower the vehicle so the tire is loaded before the final pass, and re-check after 50 to 100 miles.
Related lookups
- 2024 Toyota Corolla — Full Bolt & Torque Specs
- Wheel Lug Nut Torque Guide
- Standard Torque Specs by Grade
- Wrench & Socket Size Finder
Loading interactive lookup…