2010 Honda CR-V Brake Job Torque Specs

OEM-referenced torque, socket, and thread specs for the 4 brake fasteners you touch on a 2010 Honda CR-V brake job — caliper mounting bolts, caliper bracket bolts, slide/guide pins, and rotor hardware, including the Front Brake Caliper Bracket Bolt (torques to 101 ft-lbs (137 Nm), 17mm socket). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Caliper Bracket Bolts torque — 2010 Honda CR-V

On the 2010 Honda CR-V, the caliper bracket bolts are: Front Brake Caliper Bracket Bolt (torques to 101 ft-lbs (137 Nm), 17mm socket); Rear Brake Caliper Bracket Bolt (torques to 80 ft-lbs (108 Nm), 17mm socket). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

Caliper Slide / Guide Pins torque — 2010 Honda CR-V

On the 2010 Honda CR-V, the caliper slide / guide pins are: Front Brake Caliper Guide Pin Bolt (torques to 17-37 ft-lbs (23-50 Nm)); Rear Brake Caliper Guide Pin Bolt (torques to 17 ft-lbs (23 Nm), 12mm socket). Brake hardware is safety-critical — caliper slide pins and bracket bolts almost always take fresh thread-locker, single-use torque-to-yield bolts must be replaced, and every value should be set with a calibrated torque wrench, not an impact gun.

How to do a CR-V brake job right

Work one corner at a time so the other side holds a reference. Unbolt the caliper, hang it from the coil with wire (never let it dangle on the hose), and back the caliper bracket bolts out — those are the high-torque fasteners (commonly 80-140 ft-lbs) and are frequently torque-to-yield, so plan to replace them. Clean and lube the slide pins, or replace the pin boots if torn. Apply the specified thread-locker, start every bolt by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench. Pump the pedal to seat the pads before you drive, and re-torque the lug nuts after the wheels go back on.

Tools you need for a CR-V brake job

The 2010 Honda CR-V brake job calls for 17mm, 12mm sockets, a caliper slide-pin tool or hex/Torx bit set, a torque wrench that covers the high bracket-bolt values, thread-locker, and brake grease for the slide pins. A caliper piston compressor makes seating the new pads far easier. See the recommended tools and replacement hardware linked below.

Related lookups

Loading interactive lookup…