2020 Ford Mustang Brake Job Torque Specs

Compare 4 named brake fastener records for 2020 Ford Mustang. These records are not a universal caliper mounting or bracket torque answer. Verify the exact part, axle, variant and source against the service manual. Full bolt records for the rest of the vehicle are linked below.

Rotor Retaining Hardware records — 2020 Ford Mustang

Recorded fastener names and fields for 2020 Ford Mustang: Brake Rotor Set Screw (torques to 13 ft-lbs, 8mm socket, M6x1.0 thread). Grouping is navigation, not verification of a part's type, source or applicability. Confirm the exact fastener, axle, variant and procedure in the service manual; never substitute a slide-pin or bleeder specification for a mounting or bracket bolt.

Hydraulic (Banjo & Bleeder) records — 2020 Ford Mustang

Recorded fastener names and fields for 2020 Ford Mustang: Brake Line Banjo Bolt (torques to 32-40 ft-lbs, 14mm socket, M10x1.0 thread); Brake Bleeder Valve (torques to 8 ft-lbs, 8mm socket, M8x1.0 thread). Grouping is navigation, not verification of a part's type, source or applicability. Confirm the exact fastener, axle, variant and procedure in the service manual; never substitute a slide-pin or bleeder specification for a mounting or bracket bolt.

Other Brake Fasteners records — 2020 Ford Mustang

Recorded fastener names and fields for 2020 Ford Mustang: Brake Caliper Bolt (torques to 28 ft-lbs, 13mm socket, M8x1.25 thread). Grouping is navigation, not verification of a part's type, source or applicability. Confirm the exact fastener, axle, variant and procedure in the service manual; never substitute a slide-pin or bleeder specification for a mounting or bracket bolt.

How to do a Mustang brake job right

Consult the service manual for the exact axle and variant before starting. Identify the mounting bolts, bracket bolts and slide/guide pins separately. Bolt reuse, lubrication, threadlocker and torque-to-yield requirements are application-specific, not universal rules for a display group. Support the caliper safely without loading the hose, and use the specified tightening sequence with a calibrated torque wrench rather than an impact tool.

Tools you need for a Mustang brake job

Recorded socket sizes for 2020 Ford Mustang: 14mm, 8mm, 13mm. Other tools may include a caliper slide-pin tool or hex/Torx bit set, a torque wrench that covers the specified torque values, plus thread-locker or brake lubricant only where the manual calls for it. A caliper piston compressor makes seating the new pads far easier. See the recommended tools and replacement hardware linked below.

Related lookups

Loading interactive lookup…