2024 Hyundai Palisade Engine & Transmission Mount Torque Specs

3 engine and transmission mount fasteners are recorded for the 2024 Hyundai Palisade. Torque, socket, and thread values are shown only where a cited source verifies them, and none are verified yet. Replacing a broken or collapsed motor mount is one of the most common vibration fixes; get the torque right so the new mount seats square. Full bolt specs for the rest of the vehicle are linked below.

Engine / Motor Mounts torque — 2024 Hyundai Palisade

On the 2024 Hyundai Palisade, the engine / motor mounts are: Engine Mount Bracket Bolt (specification not verified); Engine Mount Support Bracket Bolt (specification not verified). Powertrain mount bolts are usually torque-to-yield or thread-locked from the factory — replace any single-use bolt, and confirm the value against your service manual before reassembly.

Other Powertrain Mounts torque — 2024 Hyundai Palisade

On the 2024 Hyundai Palisade, the other powertrain mounts are: Transaxle Mount Bracket Bolt (specification not verified). Powertrain mount bolts are usually torque-to-yield or thread-locked from the factory — replace any single-use bolt, and confirm the value against your service manual before reassembly.

How to replace and torque Palisade engine & transmission mounts

Support the engine (or transmission) from below with a jack and a block of wood, or from above with an engine support bar, before unbolting any mount — the powertrain will drop otherwise. Replace mounts one at a time so the others hold alignment. Raise or lower the powertrain until the new mount's bolt holes line up WITHOUT prying, then start every bolt by hand to avoid cross-threading. Make the final pass with a calibrated torque wrench, and let the powertrain settle onto all mounts before the last torque check. A mount torqued while the engine is jacked off-center pre-loads the rubber and transmits vibration.

Related lookups

Loading interactive lookup…