2024 Jeep Wrangler Lug Nut Torque Specs
The OEM lug nut torque for the 2024 Jeep Wrangler is 130 ft-lbs using a 21mm socket on M14x1.5 thread studs. Tighten in a star pattern in two passes — about half, then full — and re-check after the first 50 to 100 miles. Full bolt and torque specs for the rest of the vehicle are linked below.
What is the lug nut torque for the 2024 Jeep Wrangler?
The OEM-specified lug nut torque for the 2024 Jeep Wrangler is 130 ft-lbs. Use a calibrated torque wrench for the final pass — an impact gun cannot hit a precise value and is the most common cause of warped rotors and stretched studs. The studs are M14x1.5 thread. Re-torque after the first 50 to 100 miles of driving, because the clamp load settles as the wheel seats against the hub.
What socket size fits the Wrangler lug nuts?
The 2024 Jeep Wrangler uses a 21mm lug nut. Use a 6-point impact-rated socket rather than a 12-point chrome socket — 12-point sockets round off lug nuts under impact-driver use, which is the number-one reason a stuck nut ends up drilled out.
How to torque the Wrangler wheels correctly
Thread every lug nut on by hand first to avoid cross-threading, then torque to 130 ft-lbs in a star (criss-cross) pattern across two passes — roughly 50% then 100%. Never run one nut down fully before the others; it cocks the wheel and warps the rotor. Lower the vehicle so the tire is loaded before the final pass, and re-check after 50 to 100 miles.
Related lookups
- 2024 Jeep Wrangler — Full Bolt & Torque Specs
- Wheel Lug Nut Torque Guide
- Standard Torque Specs by Grade
- Wrench & Socket Size Finder
Loading interactive lookup…