2005 Pontiac Grand Am Suspension & Steering Torque Specs

9 front and rear suspension and steering fasteners are recorded for the 2005 Pontiac Grand Am. Torque, socket, and thread values are shown only where a cited source verifies them, and none are verified yet. Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2005 Pontiac Grand Am

On the 2005 Pontiac Grand Am, the control arms & ball joints fasteners are: Front Wheel Hub/Bearing-to-Knuckle Bolts (specification not verified); Lower Ball Joint-to-Knuckle Nut (specification not verified); Lower Control Arm-to-Frame Bolt (rear bushing) (specification not verified); Rear Trailing Arm-to-Body Bolt (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2005 Pontiac Grand Am

On the 2005 Pontiac Grand Am, the struts, shocks & springs fasteners are: Front Strut Mount-to-Body Nuts (specification not verified); Front Strut-to-Knuckle Nuts (specification not verified); Rear Strut-to-Knuckle Nut (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Sway Bar & Stabilizer Links torque — 2005 Pontiac Grand Am

On the 2005 Pontiac Grand Am, the sway bar & stabilizer links fasteners are: Front Stabilizer Bar Link Nut (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Steering (Tie Rods & Linkage) torque — 2005 Pontiac Grand Am

On the 2005 Pontiac Grand Am, the steering (tie rods & linkage) fasteners are: Outer Tie Rod End Nut (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque Grand Am suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…