2007 Saturn Ion Suspension & Steering Torque Specs

OEM-referenced torque, socket, and thread specs for the 7 front and rear suspension and steering fasteners on the 2007 Saturn Ion — including the Front Lower Ball Joint Nut (torques to 60 ft-lbs (81 Nm)). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2007 Saturn Ion

On the 2007 Saturn Ion, the control arms & ball joints fasteners are: Front Lower Ball Joint Nut (torques to 60 ft-lbs (81 Nm)); Lower Control Arm Frame Bolts (torques to 85 ft-lbs (115 Nm)). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2007 Saturn Ion

On the 2007 Saturn Ion, the struts, shocks & springs fasteners are: Front Strut-to-Knuckle Bolts (torques to 100 ft-lbs (136 Nm)); Front Strut Upper Mount Nuts (torques to 20 ft-lbs (27 Nm)). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Sway Bar & Stabilizer Links torque — 2007 Saturn Ion

On the 2007 Saturn Ion, the sway bar & stabilizer links fasteners are: Front Sway Bar Link Nut (torques to 20 ft-lbs (27 Nm)). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Steering (Tie Rods & Linkage) torque — 2007 Saturn Ion

On the 2007 Saturn Ion, the steering (tie rods & linkage) fasteners are: Outer Tie Rod End Nut (torques to 35 ft-lbs (47 Nm)). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Wheel Hub & Bearing torque — 2007 Saturn Ion

On the 2007 Saturn Ion, the wheel hub & bearing fasteners are: Front Wheel Hub/Bearing Bolts (torques to 70 ft-lbs (95 Nm)). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque Ion suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…