2010 Infiniti G37 Suspension & Steering Torque Specs

3 front and rear suspension and steering fasteners are recorded for the 2010 Infiniti G37. Torque, socket, and thread values are shown only where a cited source verifies them, and none are verified yet. Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2010 Infiniti G37

On the 2010 Infiniti G37, the control arms & ball joints fasteners are: Front Lower Control Arm Bolt (specification not verified); Rear Lower Control Arm Bolt (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2010 Infiniti G37

On the 2010 Infiniti G37, the struts, shocks & springs fasteners are: Front Strut Top Nut (specification not verified). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque G37 suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…