2024 Honda Pilot Suspension & Steering Torque Specs

OEM-referenced torque, socket, and thread specs for the 6 front and rear suspension and steering fasteners on the 2024 Honda Pilot — including the Lower Control Arm Bolt (torques to 54 ft-lbs, 17mm socket, M12x1.25 thread). Every value is safety-critical; verify against your service manual and use a calibrated torque wrench. Full bolt specs for the rest of the vehicle are linked below.

Control Arms & Ball Joints torque — 2024 Honda Pilot

On the 2024 Honda Pilot, the control arms & ball joints fasteners are: Lower Control Arm Bolt (torques to 54 ft-lbs, 17mm socket, M12x1.25 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Struts, Shocks & Springs torque — 2024 Honda Pilot

On the 2024 Honda Pilot, the struts, shocks & springs fasteners are: Front Strut Tower Nut (torques to 37 ft-lbs (50 Nm), 14mm socket, M10x1.25 thread); Front Strut-to-Knuckle Bolt (torques to 111 ft-lbs (150 Nm), 19mm socket, M12x1.25 thread); Front Strut Mount Center Nut (torques to 41 ft-lbs (55 Nm), 19mm socket, M12x1.25 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Sway Bar & Stabilizer Links torque — 2024 Honda Pilot

On the 2024 Honda Pilot, the sway bar & stabilizer links fasteners are: Stabilizer Link Nut (torques to 41 ft-lbs (55 Nm), 14mm socket, M10x1.25 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

Other Suspension Fasteners torque — 2024 Honda Pilot

On the 2024 Honda Pilot, the other suspension fasteners fasteners are: Wheel Lug Nut (torques to 80 ft-lbs (108 Nm), 19mm socket, M12x1.5 thread). Suspension and steering bolts are safety-critical — use a calibrated torque wrench, replace any prevailing-torque (locking) nut that has been removed, and confirm the value against your service manual before reassembly.

How to torque Pilot suspension & steering fasteners

Torque suspension and steering fasteners with the vehicle at ride height (wheels loaded) wherever a bushing is involved — tightening a control-arm or sway-bar bushing bolt with the suspension hanging pre-loads the rubber and it fails early. Clean the threads, start every fastener by hand to avoid cross-threading, and make the final pass with a calibrated torque wrench rather than an impact gun. Ball-joint and tie-rod castle nuts take a new cotter pin; never back a castle nut off to line up the hole — only tighten to the next slot.

Related lookups

Loading interactive lookup…