Country Clipper Mower Blade Bolt Torque Specs
Country Clipper joystick zero-turns (Charger, Boulevard, Avenue, Challenger) use one blade-bolt torque across the whole line and every manual generation: 100 ft-lb (136 N·m). No socket or thread size is stated.
What torque should I use on a Country Clipper blade bolt?
Country Clipper blade bolt torque is typically 100 ft-lb (136 N·m). Threadlocker: Not called for in the Country Clipper manuals cited below. Always confirm the exact figure for your specific model — deck design, blade thickness, and spindle stack-up move the spec by 10–20 ft-lb between models in the same brand line.
Country Clipper Charger 60" Zero-Turn blade bolt torque
100 ft-lb (136 N·m). Country Clipper Charger Product Manual P-13788 Rev C (Apr 2026), §5.7.8 Re-Install Blades (p.5.15): "Install blade, washer, and bolt to spindle assembly. Torque blade bolt to 100 ft-lbs. (136 Nm)." Followed by: "FAILURE TO CORRECTLY TORQUE THE BLADE BOLT MAY RESULT IN THE LOSS OF THE BLADE." The 2018 Charger manual P-13217 prints the same 100 ft-lbs. Socket and thread size are not stated.
Country Clipper Boulevard Zero-Turn (42"–60" Decks) blade bolt torque
100 ft-lb (136 N·m). Country Clipper Avenue/Boulevard Product Manual P-13704 Rev C (Feb 2025), §5.7.8 Re-Install Blades (p.5.12): "Install blade, washer, and bolt to spindle assembly. Torque blade bolt to 100 ft-lbs. (136 Nm)." The 2020-21 manual P-13458 prints the same figure. The Boulevard is offered with 42", 48", 54" and 60" decks. Socket and thread size are not stated.
Pro tip for Country Clipper blade service
Country Clipper prints a DANGER box directly under the torque step: "FAILURE TO CORRECTLY TORQUE THE BLADE BOLT MAY RESULT IN THE LOSS OF THE BLADE WHICH CAN CAUSE SERIOUS INJURY OR DEATH." Single value, 100 ft-lb — use a torque wrench, not an impact.
Step-by-step Country Clipper blade-bolt reinstall
Disconnect the spark plug, engage parking brake, tip the mower (carb-side up). Block the blade with a 2×4 — never your hand. Use a 1/2" drive breaker bar with a 6-point socket. Clean threads with brake cleaner. No threadlocker needed unless your model manual specifies it. Torque in one smooth pull with a calibrated torque wrench. Re-check after first hour of cutting.
Related lookups
- All Mower Blade Bolt Torque Specs
- Briggs & Stratton Blade Bolt Torque
- Walk-Behind Mower Blade Bolt Torque
- Country Clipper Charger 60" Zero-Turn (100 ft-lb (136 N·m))
- Country Clipper Boulevard Zero-Turn (42"–60" Decks) (100 ft-lb (136 N·m))
Loading interactive lookup…